Low cost replacement for screws and rivets. Clips snap into round holes securely holding in metal, plastic, and a variety of materials. Ideal for assembling gaskets, name-plates, and lightweight panels to other panels and components.

Installation: As fastener is pushed into hole, hollow prong compresses, returning to its original shape once it passes through hole.

pf14-1-2

PART NUMBERHEAD STYLEPANEL HOLE DIAMETER**PANEL THICKNESS RANGE AHEAD HEIGHT BHEAD DIAMETER CPRONG LENGTH D
254-080845-00BINDER.123-.127.080-.1000.040.270.33
254-090401-00ROUND.131-.141.060-.0900.150.4060.275
254-090501-00ROUND.131-.141.080-.1250.10.4060.365
254-090501-01ROUND.131-.141.080-.1250.10.30.365
254-090601-00ROUND.131-.141.115-.1600.10.4060.437
254-090601-01ROUND.131-.141.115-.1600.10.30.437
254-090301-00ROUND.135-.140.060-.0700.060.30.33
254-120601-00TRUSS.182-.192.100-.1600.060.3750.437
254-160801-00TRUSS.240-.260.095-.2180.0550.50.63
254-160801-01TRUSS.240-.260.095-.2180.090.8750.63
254-160801-03TRUSS.240-.260.095-.2180.0550.750.63
254-160801-02PAN.240-.260.095-.2180.060.450.46

*NOTE–When installing CANOE CLIPS:
1. It is desirable that the burr side of hole be opposite CANOE CLIP entry.
2. The surface condition of the hole edge has a definite bearing on the ease with which a CANOE CLIP can be inserted and how well it will fit and hold. Indicated hole sizes are final, i.e.: after painting, enameling, etc. For hole sizes that will provide the best combination of easy installation and secure fit, please refer to the accompanying General Fit Guide.
3. Dimensions listed are nominal.
General fit guide
Surface condition: Hole size
Porcelain: Low end of indicated range
Enamel: Slightly below middle of indicated range
Paint: Middle of indicated range
Plastic panel: Middle of indicated range
Raw metal: High end of indicated range