|
Wire Management
|
A. Nylon Clips For Wire & Cable
Routing |
|
1. Adhesive Backed Clips: Just peel
from protective strip and press into place. Aggressive
rubber based adhesive holds securely to any clean,
smooth, hard surface. Simply snap wires, cords or cable
into these U.L. recognized clips.
View PDF Catalog Page: Adhesive Backed Clips |
97-98 |
2. Snap-in Clips: These
reusable clips snap positively into mounting hole in
panel to securely position wires and cables.
View PDF Catalog Page: Snap-in Clips
|
99-100 |
3. "Top Entry" Snap-in Clips: Snap
positively into mounting holes. Ideal for narrow width,
top-entry applications where space is limited. Regular "gate" provides
tension fit for cables or wires. Optional latch gate
securely locks wires and cables in clip.
View PDF Catalog Page: "Top Entry" Snap-in Clips
|
102 |
4. "Side Entry" Snap-in Clips: Clips
snap positively into mounting holes. Designed for low-profile,
side entry applications where clearance is a problem.
View PDF Catalog Page: "Side Entry" Snap-in
Clips
|
102 |
5. "Clip-on" Clips: Slip
over panel edge and snap securely into prepared
hole near panel edge. Minimal clearance required.
View PDF Catalog Page: "Clip-On" Clips
|
103 |
6. Screw Down Clips: Fastened to panel
with screw or plastic push-in fastener. Clip snaps
open for placement or removal of wires and cables;
snaps shut to secure them.
View PDF Catalog Page: Screw Down Clips
|
100 |
7. "Clip Over" Clips: Installed
over screw or stud. Swings open to accept
wire or cable bundles; swings shut to secure them.
View PDF Catalog Page: Clip Over Clips
|
103 |
8. Adjustable Straps: Plastic straps
easily adjust to wire and cable bundles of varying
diameters. Straps are available with snap-in prongs
or hole to accommodate secondary fasteners.
View PDF Catalog Page: Adjustable Straps
|
103 |
B. Nylon Clips
for Tubes |
1. Tubular Clips: Snap into panel
holes to securely hold condensers and
other tubular parts. Function as shock absorbers and insulators.
View PDF Catalog Page: Tubular Clips |
100 |
2. Tubular Mounting Clips: Snap securely
into place to retain various sizes of tubes or cables.
Maintain required spacing away from panels or other
parts.
View PDF Catalog Page: Tubular Mounting Clips |
100 |
Strain Relief Grommets |
1. Plastinite™ Strain Relief Grommets:
These one-piece ITW Fastex® plastic
grommets snap easily into panel holes to protect cords
from push or pull forces and abrasion.
View PDF Catalog Page: Plastinite™ Strain Relief Grommets |
101 |
2. Nylon Strain Relief: Snap-in installation.
Protect cords when switching power supply.
View PDF Catalog Page: Nylon Strain Relief |
104 |
Cable Ties |
1. CABLE TIES: These non-abrasive, non-conductive CABLE
TIES safely secure small or large diameter cables and wires in a
wide range of bundle sizes. WCL Cable Ties range in length from
2.4" all the way to 35.5" with loop tensile strength up to 250 lbs.!
View Web Page: Cable
Ties |
|
This
diverse offering of plastic fasteners and assembly components
supports